Genuine Mazda Front Brake Caliper Support Bracket • NF47-33-281

Genuine Mazda NF47-33-281 Front Brake Caliper Support Bracket

Replacement Genuine Mazda front brake caliper support bracket for Mazda MX-5 Mk3 / Mk3.5 / Mk3.75 (NC) models listed in the compatibility table.

The front brake caliper support bracket, also known as a caliper carrier or disc brake caliper bracket, mounts the front brake caliper in the correct position over the brake disc. It provides the mounting points for the caliper assembly and helps maintain correct brake pad alignment, caliper position and braking performance.

This Genuine Mazda bracket is used on the front brake assembly and can be used on the left-hand or right-hand front side where applicable. It is especially useful when the original bracket is corroded, damaged, seized, has worn slider pin bores, damaged threads, or is unsuitable for reuse during front brake refurbishment.

This part is commonly replaced during brake caliper rebuilds, front brake overhauls, seized caliper repairs, brake carrier corrosion repairs, or when replacing damaged front brake mounting hardware.

• Part type: Front brake caliper support bracket / caliper carrier / disc brake caliper bracket
• Primary use: Front brake caliper mounting and support
• Location: Front brake assembly
• Position: Left front or right front
• Quantity supplied: 1
• Brand: Genuine Mazda
• Part No.: NF47-33-281
• Also referenced as: NF4733281
• Designed for Mazda MX-5 NC front brake applications listed in the compatibility table

Fitment advice: Designed for the Mazda MX-5 NC front brake applications listed in the compatibility table. This is a front brake caliper support bracket and is not for the rear brake assembly. This listing is for one individual bracket; two front brackets are fitted per vehicle, one per side.

Other items to consider: When changing this part, you may also want to consider purchasing related front brake service items such as caliper slider pins, slider pin boots, caliper mounting bolts, front brake pads, front brake discs, brake pad fitting hardware, brake cleaner, high-temperature brake grease and any corroded or damaged brake fixings found during removal.

Useful tools / consumables: Jack and axle stands or vehicle lift, socket set, breaker bar, torque wrench, brake cleaner, wire brush, penetrating oil, high-temperature brake grease, thread cleaning tools and suitable tools for removing the front brake caliper, brake pads and brake disc if required.

Difficulty guide: DIY Difficulty: Moderate. Replacement normally involves removing the wheel, front brake caliper, brake pads and associated mounting hardware. Corroded or seized brake bolts and slider components can increase difficulty. All brake fasteners should be tightened to Mazda workshop manual torque specification.

Why Genuine Mazda? Genuine Mazda brake caliper support brackets are manufactured to the original specification for correct fit, caliper alignment, slider pin positioning, thread quality and brake pad location. Using the correct OE bracket helps maintain safe braking performance, even pad contact and proper front brake assembly fitment.

What’s in the box: One Genuine Mazda front brake caliper support bracket. Brake caliper, brake pads, brake discs, slider pins, bolts, boots and additional hardware are not included unless listed separately.

Installation notes: Clean all mating surfaces before installation, inspect the brake caliper, slider pins, boots, brake pads and discs, and replace any worn or corroded related parts. Lubricate slider components with suitable brake grease where applicable, torque all fasteners to Mazda specification and check brake operation before returning the vehicle to service.